 |
STEP 1:
Loosen seat floor bolt, choose desired bracket, then assemble with screw base, washer,
and tighten. Please refer to steps 1a and 1b for desired assembly. |
 |
Step 1a: Attach #1-Link Bracket over seat bolt area. Screw in seat floor bolt with washer and tighten
over link bracket. Apply #2-Base and #3-Screw to the link bracket securely. |
 |
Step 1b: Attach #1-Link
Bracket over seat bolt area. Screw in seat floor bolt with washer and tighten
over link bracket. Apply #2-Base and #3-Screw to the link bracket securely. |
 |
STEP 2: Place the stand base over screw base, clamp the quick release
handle tightly to secure. |
 |
STEP 3: Rotate joint knob to adjust and tighten at desired angle. |
 Click here for printable installation guide! |
|
 |
|
 |
STEP 4: Use the quick release handle to adjust the inner length of the
stand and/or rotate the section of stand to desired angle. |
 |
STEP 5: After adjusting to desired position, rest your flat panel computer
on the laptop tray and fasten with #6-Velcro Belts. |
 |
CAUTION:
- Please tighten all screws to ensure that the stand is secure
- NOT FOR USE WHILE DRIVING. Please use while parked.
- Do not ut stand inway of airbag deployment area for safety reasons.
- Max load: when moving 5 kg, when immobile 10 kg.
|
|
